London driveway cleaning · Central London
We work in Kensington and Chelsea every week — the densest borough in the country — white stucco crescents, museum quarter and the portobello and world's end ends. Driveway cleaning is priced against that reality, not a national average.
Fixed prices
| Job | From | Typical time | What sets the price |
|---|---|---|---|
| Tarmac or plain concrete driveway, up to 20m² | £120 | 1–1.5 hrs | A flat, sealed surface with no joints to protect, so it's the fastest and lowest-risk driveway to hot-water wash at full pressure. |
| Block paving clean only, per m² | £4.50 | By area | Block paving has hundreds of joints per square metre; the pressure is kept low enough not to blow the jointing sand out before we've had the chance to resand it. |
| Block paving clean and re-sand with kiln-dried sand, per m² | £7.50 | By area | Kiln-dried sand has to be brushed in and vibrated down into every joint once the paving is fully dry, which is what actually stops the blocks rocking loose over winter. |
| Resin-bound driveway clean, per m² | £5.50 | By area | Resin-bound surfaces are cleaned at a lower pressure with a soft rotary head, because a standard turbo nozzle can strip aggregate out of the resin binder. |
| Pattern-imprinted concrete clean and reseal, per m² | £6.50 | By area | Imprinted concrete needs its sealant reapplied after cleaning or the colour fades and the surface starts absorbing oil and tyre marks again within a season. |
| Oil stain or moss treatment, per stain or per m² | £15 / £3 | Added to visit | Oil needs a degreaser dwell time before the hot-water wash; moss and algae need a biocide treatment first so it doesn't just regrow from the roots left in the joints. |
Tarmac or plain concrete driveway, up to 20m²
£120 · 1–1.5 hrs
A flat, sealed surface with no joints to protect, so it's the fastest and lowest-risk driveway to hot-water wash at full pressure.
Block paving clean only, per m²
£4.50 · By area
Block paving has hundreds of joints per square metre; the pressure is kept low enough not to blow the jointing sand out before we've had the chance to resand it.
Block paving clean and re-sand with kiln-dried sand, per m²
£7.50 · By area
Kiln-dried sand has to be brushed in and vibrated down into every joint once the paving is fully dry, which is what actually stops the blocks rocking loose over winter.
Resin-bound driveway clean, per m²
£5.50 · By area
Resin-bound surfaces are cleaned at a lower pressure with a soft rotary head, because a standard turbo nozzle can strip aggregate out of the resin binder.
Pattern-imprinted concrete clean and reseal, per m²
£6.50 · By area
Imprinted concrete needs its sealant reapplied after cleaning or the colour fades and the surface starts absorbing oil and tyre marks again within a season.
Oil stain or moss treatment, per stain or per m²
£15 / £3 · Added to visit
Oil needs a degreaser dwell time before the hot-water wash; moss and algae need a biocide treatment first so it doesn't just regrow from the roots left in the joints.
Domestic prices are the total you pay; landlord, letting agent and managing agent invoices are plus VAT at 20%. Sweeping up loose debris, bagging spent sand and a rinse-down of adjoining paths disturbed by the work are included. Where a parking permit or bay suspension is needed to run hoses from the van it is itemised in the written quote.
Working in Kensington and Chelsea
Kensington and Chelsea is built from stucco-fronted terraces, mansion flats, mews houses and the lancaster west and world's end estates, and the mix changes street by street — Bayswater (W2), Chelsea (SW3) and Earl's Court (SW5) each behave differently on the day.
Royal Borough of Kensington and Chelsea sets the constraint: some of the tightest cpzs in london, mews entrances under 2.1m and communal-stair-only access in many mansion blocks. Locally that means hotel servicing congestion, permit bays and five-storey walk-ups and cadogan estate parking rules, king's road red-route loading and mews arches with height limits. Part of Kensington and Chelsea sits inside the Congestion Charge zone, so the charge is quoted as its own line rather than hidden in the labour rate.
Several streets in Kensington and Chelsea sit inside a conservation area where the front boundary treatment, including a stone or brick driveway, is part of what the designation protects. Royal Borough of Kensington and Chelsea does not usually need to be told about a clean, but jet washing at too high a pressure can strip old lime mortar joints on a period surface, which is a repair cost, not a cleaning one — we drop the pressure on anything older than standard concrete block paving.
Kensington and Chelsea took its present shape because market gardens turned into the great exhibition's albertopolis, then estate-built stucco terraces for the victorian wealthy.
Scope
Method
Step 1
Tarmac, block paving, resin-bound or imprinted concrete, and roughly how many square metres — that sets both the pressure setting and the price.
Step 2
Cleaning, any re-sanding or resealing and the tip fee for spent sand are shown as separate lines rather than folded into one number.
Step 3
A biocide is applied to joints and shaded corners before washing, because pressure alone leaves roots behind that regrow within weeks.
Step 4
Hot water for tarmac and concrete; a stepped-down pressure and softer head for block paving, resin-bound and imprinted surfaces.
Step 5
Kiln-dried sand is brushed and vibrated into block paving joints once dry; sealant is reapplied on resin-bound and imprinted concrete driveways that include it.
Coverage
Also in this borough
Front paths, side returns and communal walkways cleaned without disturbing loose flags.
York stone, sandstone, composite and softwood decking cleaned at the right pressure for the surface.
The wider outdoor jet washing hub covering every hard surface we clean.
Full internal clean to the same visit if the property is changing hands.
A full top-to-bottom clean of the property once it has been emptied.
Rubble, plasterboard and strip-out waste cleared with waste transfer notes issued.
Tarmac or plain concrete driveway, up to 20m² starts at £120 in Kensington and Chelsea, and the ladder runs up to £15 / £3 for the largest job on the table above. Surface type first, then area. Block paving and resin-bound surfaces cost more per square metre than plain concrete because the lower pressure needed takes longer to cover the same area, and re-sanding or resealing is a second pass, not an add-on to the wash. Part of the borough is inside the Congestion Charge zone, so a £15 daily charge is added as its own line when the job falls inside the charging hours.
We cover the whole borough: SW10, SW3, SW5, SW7, W10, W11, W14, W2 and W8. On the ground that includes Bayswater, Chelsea, Earl's Court, Holland Park, Kensington and Ladbroke Grove.
Same-week across every borough, with the pressure and nozzle setting confirmed from your photos before the technician is booked so it isn't decided on arrival. Central London is covered by crews already working in the borough, so travel time is not billed on top.
Some of the tightest CPZs in London, mews entrances under 2.1m and communal-stair-only access in many mansion blocks. Where a permit or a bay suspension is needed we arrange it with Royal Borough of Kensington and Chelsea and show the cost in the quote before you agree it. Nothing is added afterwards.
Yes. Stucco-fronted terraces, mansion flats, mews houses and the Lancaster West and World's End estates is exactly the stock we work in daily. Where there is no lift, the crew size is set by the floor level at quote stage, so a third-floor walk-up is priced as a third-floor walk-up rather than re-quoted on the doorstep.
Wastewater containing detergent or biocide is contained and directed away from surface water drains during the clean, in line with water company trade effluent guidance, rather than allowed to run off into the road gutter. Certificates go out with the booking confirmation, which is what Royal Borough of Kensington and Chelsea tenancies and most local managing agents ask for.
One technician and a van-mounted hot-water pressure washer for most driveways; two on larger block-paving jobs where re-sanding is included, since brushing sand in is a second task run alongside the wash. Vehicles are ULEZ-compliant, which matters in every Kensington and Chelsea postcode, and the crew carries everything needed to complete the job in one visit.
Replacing cracked, sunken or missing block paving units — that's a re-lay job, quoted separately by our paving team, Structural repointing of natural stone or brick driveways, which needs a mason rather than a pressure wash and Removing oil that has soaked deep into porous stone over years, which may need professional poulticing rather than a surface treatment. If something on that list turns up in Kensington and Chelsea, we tell you at survey and point you at the right trade rather than taking the booking anyway.
Free quote · 1-hour reply
Send a few details and you get a written quote for your Kensington and Chelsea address, with permits and charges shown separately.
No deposit is taken until the price and slot are confirmed in writing.
Hello Services provides excellent jet washing service that completely transformed my driveway , highly recommended at this price .
Sardar gave me a great spring clean and the patio clean with professional chemicals. It was fast and reliable service. Will definitely do it again!
Sardar jet washed my front and back patios. He did a great job, was on time, and communicated well. He checked that I was happy with the work and was very neat and tidy while working and afterwards.
Read all 6 Jet Washing reviews →
Quoted verbatim from reviews customers left on our public Google and Trustpilot profiles. Nothing is edited, shortened beyond the link above, or written by us.
