London cat flap fitting · Central London
We work in Kensington and Chelsea every week — the densest borough in the country — white stucco crescents, museum quarter and the portobello and world's end ends. Cat flap fitting is priced against that reality, not a national average.
Fixed prices
| Job | From | Typical time | What sets the price |
|---|---|---|---|
| Timber door | £75 | 45–60 min | Cut, chamfered and sealed so the door edge does not swell in winter. |
| uPVC door panel | £95 | 1–1.5 hrs | The panel is cut in place with the frame protected, and the cut edge capped so water cannot track in. |
| Composite door | £120 | 1–2 hrs | A composite has a foam core between two skins; both faces must be cut cleanly and the core sealed. |
| Brick or block wall, up to 350mm | £190 | 2–3 hrs | Core-drilled both sides with a tunnel liner fitted, so the cavity is never left open. |
| Glass panel — cut-out supplied by a glazier | £110 | 1 hr | Toughened glass cannot be cut on site; we template it, fit the replacement pane and set the flap. |
| Microchip flap set-up and training mode | £25 | 15–20 min | Chips registered, curfew and selective entry configured, and the flap left on training setting. |
Timber door
£75 · 45–60 min
Cut, chamfered and sealed so the door edge does not swell in winter.
uPVC door panel
£95 · 1–1.5 hrs
The panel is cut in place with the frame protected, and the cut edge capped so water cannot track in.
Composite door
£120 · 1–2 hrs
A composite has a foam core between two skins; both faces must be cut cleanly and the core sealed.
Brick or block wall, up to 350mm
£190 · 2–3 hrs
Core-drilled both sides with a tunnel liner fitted, so the cavity is never left open.
Glass panel — cut-out supplied by a glazier
£110 · 1 hr
Toughened glass cannot be cut on site; we template it, fit the replacement pane and set the flap.
Microchip flap set-up and training mode
£25 · 15–20 min
Chips registered, curfew and selective entry configured, and the flap left on training setting.
Prices are labour and fitting materials; the flap itself can be supplied at cost or you can provide your own. Glass cut-outs are quoted by a glazier and shown separately. Where a lease or a landlord consent is needed we will tell you before booking rather than after. Permits, ULEZ and the Congestion Charge where they apply are itemised.
Working in Kensington and Chelsea
What our crews walk into in Kensington and Chelsea is stucco-fronted terraces, mansion flats, mews houses and the lancaster west and world's end estates, and the mix changes street by street — Bayswater (W2), Chelsea (SW3) and Earl's Court (SW5) each behave differently on the day.
Royal Borough of Kensington and Chelsea sets the constraint: some of the tightest cpzs in london, mews entrances under 2.1m and communal-stair-only access in many mansion blocks. Locally that means hotel servicing congestion, permit bays and five-storey walk-ups and cadogan estate parking rules, king's road red-route loading and mews arches with height limits. Part of Kensington and Chelsea sits inside the Congestion Charge zone, so the charge is quoted as its own line rather than hidden in the labour rate.
Most flats in Kensington and Chelsea are leasehold, and managing agents here routinely ask for a public liability certificate and a method note before a contractor drills anything. We send both with the booking confirmation.
Kensington and Chelsea took its present shape because market gardens turned into the great exhibition's albertopolis, then estate-built stucco terraces for the victorian wealthy.
Scope
Method
Step 1
Timber, uPVC, composite, glass or masonry — plus what is behind it. A cavity wall or a glazed panel changes the job completely.
Step 2
Measured to your cat's chest height, so an older or arthritic cat still uses it in two years' time.
Step 3
Template marked, cut from both faces to avoid blow-out, and the edge lined, capped or sealed.
Step 4
Flap fitted square, sealed against draughts and rain, and the fixings drawn up evenly so the frame does not bow.
Step 5
Microchips registered, curfew set if you want one, and the flap left in training mode with the mess cleared.
Coverage
Also in this borough
Gripper, underlay, doorbars and stairs fitted, with the old floor lifted and taken away.
Wardrobes, beds, desks and storage built, levelled and anchored to the wall.
Floating and bracketed shelving into plaster, brick, stud and dot-and-dab.
Garden sets, loungers, BBQs, parasols and shed bases built outside and weather-fixed.
Bath and shower screens fitted, sealed and tested so the seal holds, not just looks right.
Timber door starts at £75 in Kensington and Chelsea, and the ladder runs up to £25 for the largest job on the table above. The material sets the price. Timber is quickest, uPVC and composite need capping, and a masonry wall means core drilling and a lined tunnel. Part of the borough is inside the Congestion Charge zone, so a £15 daily charge is added as its own line when the job falls inside the charging hours.
We cover the whole borough: SW10, SW3, SW5, SW7, W10, W11, W14, W2 and W8. On the ground that includes Bayswater, Chelsea, Earl's Court, Holland Park, Kensington and Ladbroke Grove.
Most cat flap bookings are within 48 hours and take a single short visit. Central London is covered by crews already working in the borough, so travel time is not billed on top.
Some of the tightest CPZs in London, mews entrances under 2.1m and communal-stair-only access in many mansion blocks. Where a permit or a bay suspension is needed we arrange it with Royal Borough of Kensington and Chelsea and show the cost in the quote before you agree it. Nothing is added afterwards.
Yes. Stucco-fronted terraces, mansion flats, mews houses and the Lancaster West and World's End estates is exactly the stock we work in daily. Where there is no lift, the crew size is set by the floor level at quote stage, so a third-floor walk-up is priced as a third-floor walk-up rather than re-quoted on the doorstep.
Fitters carry £5m public liability cover. We check leasehold and landlord consent before cutting anything, and we will not cut a communal fire door — that would void its rating and the block's fire strategy. Certificates go out with the booking confirmation, which is what Royal Borough of Kensington and Chelsea tenancies and most local managing agents ask for.
One fitter for doors and panels; two where a wall tunnel is core-drilled and the debris has to be carried out of a flat. Vehicles are ULEZ-compliant, which matters in every Kensington and Chelsea postcode, and the crew carries everything needed to complete the job in one visit.
Cutting toughened or laminated glass on site — it must be replaced by a glazier, Fire doors in communal areas, where a cut-out would void the fire rating and Structural openings through a lintel or an insulated cavity closer without a survey. If something on that list turns up in Kensington and Chelsea, we tell you at survey and point you at the right trade rather than taking the booking anyway.
Free quote · 1-hour reply
Send a few details and you get a written quote for your Kensington and Chelsea address, with permits and charges shown separately.
No deposit is taken until the price and slot are confirmed in writing.
Sulltan is the best handyman in London. He is very reliable and professional. I highly recommend.
I booked online last minute, as I needed a handyman urgently for the next day. When I called Hello Services, I spoke to Michelle and she was extremely helpful and arranged everything within 15 mins. Adam the handy man then came to fix my wardrobe sliding door, which were jammed and came off the ledge… Read in full →
Sulltan is the best handyman in London , Highly recommend ......
Read all 26 cat flap fitting reviews →
Quoted verbatim from reviews customers left on our public Google and Trustpilot profiles. Nothing is edited, shortened beyond the link above, or written by us.
