Cat flap fitting in Wigan

Almost always, with the right method. Local walls are double-brick ground floors and lath-and-plaster above, which means one anchor downstairs and a joist-hunt upstairs, so the substrate is scanned and tested first and the fixing chosen to suit. A standard Wigan job takes around 123 minutes.

Access here is typically a space found within a few doors of the house, with anything long carried in flat and turned in the front room. Wigan Council controls parking in WN1, so any permit or visitor bay is arranged before the visit and included in the quoted price — never added afterwards.

Timber or composite door starts at from £79 and through a masonry wall is from £159. The price is set by what the flap is going into — timber, uPVC, glass or a masonry wall and fixed in writing before we travel. Rates are identical across WN1, WN3, WN5, WN6 — postcode never changes the figure.

Yes. Saturday, Sunday and after-6pm slots run across Wigan at the same fixed price, which suits tenancy check-ins, completion days and businesses that cannot lose trading hours. Same rates in Ince-in-Makerfield, Hindley, Standish.

We do everything that can be done, photograph the problem with the part reference and tell you exactly what is needed. Returning to finish carries no second call-out charge in Wigan.

Not into the existing sealed unit — cutting it would destroy it. We order a replacement toughened pane with the hole pre-cut to your flap and swap the unit over. That holds across WN1, WN3, WN5, WN6 at one fixed price.

Most Wigan homes have a solid timber or half-glazed timber back door onto the yard, often the original door with a century of paint on it, which cuts cleanly with a hole cutter and takes a flap without any structural worry The survey confirms the construction before anything is cut, and the flap, fixing kit and liner are matched to that door rather than to a one-size box.

Not into the existing unit — cutting a sealed double-glazed pane breaks the seal and the glass. Locally, upper panels are frequently single-glazed or a later sealed unit dropped into the old frame — the timber panel below is the sensible target, and the glass is left alone Where glass is the only route, we measure the unit and order a replacement toughened pane with the aperture cut at the factory, then fit the flap into the new pane.

Yes. External walls here are typically 9-inch solid brick with no cavity, so a through-wall fit needs a core-drilled opening and a long lined tunnel with an internal and external frame rather than a standard door flap The opening is core drilled, the tunnel lined and sealed at both faces, and the internal and external frames set level so the flap swings freely and stays weathertight.

Small rear yards opening onto a shared ginnel or back alley, so the flap normally goes in the back door and the cat routes out through the gate. On that basis, a microchip selective-entry flap is worth it here — ginnels carry a lot of cat traffic and a magnetic collar flap lets every neighbouring cat in. If a flap genuinely is not workable at your property, we will say so on the survey rather than sell you a fitting.