Cat flap fitting in Moss Side

Almost always, with the right method. Local walls are nine-inch brick downstairs, timber-and-plaster partitions upstairs and the occasional later block infill in the back bedroom, so the substrate is scanned and tested first and the fixing chosen to suit. A standard Moss Side job takes around 35 minutes.

Access here is typically kerbside standing near the door and a careful turn at the bottom of the stairs for anything longer than a metre. Manchester City Council controls parking in M14, so any permit or visitor bay is arranged before the visit and included in the quoted price — never added afterwards.

Timber or composite door starts at from £79 and through a masonry wall is from £159. The price is set by what the flap is going into — timber, uPVC, glass or a masonry wall and fixed in writing before we travel. Rates are identical across M14, M16 — postcode never changes the figure.

Yes. Everyone attending a Moss Side job is DBS-checked, reference-verified and covered by £1m public liability insurance. You get their name before the visit and they carry photo ID.

Yes, and it is the cheapest way to buy the time. Cat flap fitting sits happily alongside anything else on our handyman list — send the whole list and we will price it as one Moss Side visit rather than several call-outs.

Yes. Saturday, Sunday and after-6pm slots run across Manchester at the same fixed price, which suits tenancy check-ins, completion days and businesses that cannot lose trading hours. Same rates in Hulme, Whalley Range, Fallowfield.

Most Moss Side homes have a half-glazed uPVC or timber back door with a solid lower panel, which is the most straightforward surface there is for a flap The survey confirms the construction before anything is cut, and the flap, fixing kit and liner are matched to that door rather than to a one-size box.

Not into the existing unit — cutting a sealed double-glazed pane breaks the seal and the glass. Locally, double-glazed units in the upper half of the door, untouched — the flap goes in the panel below the glass line, well clear of the sealed unit Where glass is the only route, we measure the unit and order a replacement toughened pane with the aperture cut at the factory, then fit the flap into the new pane.

Yes. External walls here are typically standard cavity wall of roughly 275mm, which suits a factory tunnel extension without any special core drilling The opening is core drilled, the tunnel lined and sealed at both faces, and the internal and external frames set level so the flap swings freely and stays weathertight.

Private rear gardens with a gate, so the back door is the natural route and the cat has somewhere safe to land. On that basis, a four-way locking flap or microchip flap set to curfew suits family houses where the cat is in at night. If a flap genuinely is not workable at your property, we will say so on the survey rather than sell you a fitting.