Carpet fitting in Marple

Almost always, with the right method. Local walls are solid mill brick and the odd cast-iron column, which needs an SDS drill and resin anchors rather than the plugs supplied in the box, so the substrate is scanned and tested first and the fixing chosen to suit. A standard Marple job takes around 171 minutes.

Access here is typically loading through the residents’ car park with the lift booked, so nothing wide is dragged through a stairwell. Stockport Council controls parking in SK6, so any permit or visitor bay is arranged before the visit and included in the quoted price — never added afterwards.

Single room starts at from £129 and stairs with winders and landing is from £249. The price is set by the floor area, the number of stairs and whether the old carpet is being lifted and fixed in writing before we travel. Rates are identical across SK6 — postcode never changes the figure.

Yes. Winders are cut and fitted individually rather than folded round, which takes longer but is the only way the treads sit tight and wear evenly. The same answer applies to every Marple booking.

Yes, along with the underlay, gripper and nails, disposed of through a licensed carrier with a waste transfer note if you need one. The same answer applies to every Marple booking.

Yes. Everyone attending a Marple job is DBS-checked, reference-verified and covered by £1m public liability insurance. You get their name before the visit and they carry photo ID.

Most Marple homes have cold solid floors — flagstone, early concrete or slate laid straight onto hardcore — with timber upstairs running out of level across old joists. Before any gripper goes down we do the prep that floor needs: levelling compound or packing across the dips, a damp check on any solid ground floor, and ply where the upstairs boards have dropped between joists. Prep is quoted on the survey with a price, not added on the day.

Typical here is a steep quarter-turn flight with deep winders and often an open riser or two, cut and stitched tread by tread with a stair tool rather than stretched. Straight treads are stretched and folded off one length; winders and open risers are templated, cut and stitched individually so the pile direction stays consistent down the flight and the nosings hold their shape.

Irregular room shapes with thick reveals and deep window seats, so templates are cut on site and the wastage allowance runs higher than a square room. Standard broadloom comes in 4m and 5m widths, so we measure on the survey and tell you before you buy whether the room fits seam-free — and if a seam is needed, where it will fall.

For this stock we specify thermal underlay on the solid floors to lift a cold room, with crumb rubber on the stairs where a steep flight needs grip underfoot. Underlay does most of the work for warmth, step and how long the pile stays upright, so it is matched to the floor and the traffic rather than sold as one grade for the whole house.