Carpet fitting in Irlam

Almost always, with the right method. Local walls are solid nine-inch brick with original lath and plaster on the upper floors, so fixings change room by room, so the substrate is scanned and tested first and the fixing chosen to suit. A standard Irlam job takes around 47 minutes.

Access here is typically on-street parking a short carry from the front door, with long boards angled through the hall rather than the rear alley. Salford City Council controls parking in M44, so any permit or visitor bay is arranged before the visit and included in the quoted price — never added afterwards.

Single room starts at from £129 and stairs with winders and landing is from £249. The price is set by the floor area, the number of stairs and whether the old carpet is being lifted and fixed in writing before we travel. Rates are identical across M44 — postcode never changes the figure.

We do everything that can be done, photograph the problem with the part reference and tell you exactly what is needed. Returning to finish carries no second call-out charge in Irlam.

Both. Most customers buy their own and we fit it; if you would rather we sourced it, send the room sizes and we will quote the carpet, underlay and fitting as one figure. That holds across M44 at one fixed price.

Yes. Winders are cut and fitted individually rather than folded round, which takes longer but is the only way the treads sit tight and wear evenly. The same answer applies to every Irlam booking.

Most Irlam homes have 1930s tongue-and-groove boards over joists downstairs with a solid hearth, and boards upstairs that have been lifted for rewiring. Before any gripper goes down we do the prep that floor needs: boards re-fixed and punched, hardboard overlay across the bay where the floor dips, and the hearth edge trimmed so the gripper sits square. Prep is quoted on the survey with a price, not added on the day.

Typical here is a straight flight with a quarter turn onto a half-landing and a spindled balustrade to cut around at every spindle. Straight treads are stretched and folded off one length; winders and open risers are templated, cut and stitched individually so the pile direction stays consistent down the flight and the nosings hold their shape.

Bay-fronted lounges running 3.8–4.4m including the bay, which pushes the wider ones onto a 5m roll to stay seam-free. Standard broadloom comes in 4m and 5m widths, so we measure on the survey and tell you before you buy whether the room fits seam-free — and if a seam is needed, where it will fall.

For this stock we specify 10mm PU foam in the reception rooms with crumb rubber on the flight and half-landing where the turn takes the wear. Underlay does most of the work for warmth, step and how long the pile stays upright, so it is matched to the floor and the traffic rather than sold as one grade for the whole house.