Carpet fitting in Atherton

Single room starts at from £129 and stairs with winders and landing is from £249. The price is set by the floor area, the number of stairs and whether the old carpet is being lifted and fixed in writing before we travel. Rates are identical across M46 — postcode never changes the figure.

88% of Atherton bookings are offered a same or next-day slot. Send photos and the details before midday and there is usually someone with you that afternoon, with the visit length agreed up front.

Almost always, with the right method. Local walls are solid brick outer walls with crumbly Victorian plaster, so holes are drilled clean and made good rather than punched through, so the substrate is scanned and tested first and the fixing chosen to suit. A standard Atherton job takes around 53 minutes.

We do everything that can be done, photograph the problem with the part reference and tell you exactly what is needed. Returning to finish carries no second call-out charge in Atherton.

Both. Most customers buy their own and we fit it; if you would rather we sourced it, send the room sizes and we will quote the carpet, underlay and fitting as one figure. Nothing changes for Atherton — Wigan rates are identical.

Yes. Winders are cut and fitted individually rather than folded round, which takes longer but is the only way the treads sit tight and wear evenly. That holds across M46 at one fixed price.

Most Atherton homes have original softwood floorboards over joists, usually cupped, gappy and springing at the hearth and doorways after a century of lifting for pipework. Before any gripper goes down we do the prep that floor needs: loose boards screwed back to the joists, proud nails punched down and a 3mm hardboard or 6mm ply overlay laid across the worst runs so the carpet reads flat instead of telegraphing every board line within a season. Prep is quoted on the survey with a price, not added on the day.

Typical here is a narrow straight flight turning onto two or three winders at the top, so treads and risers are cut, folded and stitched individually rather than run off one length. Straight treads are stretched and folded off one length; winders and open risers are templated, cut and stitched individually so the pile direction stays consistent down the flight and the nosings hold their shape.

Front rooms 3.6–4.2m across the bay, so a 4m broadloom is tight and the wider rooms take a planned seam set out of the traffic line, or a 5m roll where the hall will take the carry. Standard broadloom comes in 4m and 5m widths, so we measure on the survey and tell you before you buy whether the room fits seam-free — and if a seam is needed, where it will fall.

For this stock we specify 8–11mm PU foam over the overlaid boards for warmth and step, dropping to crumb rubber on the stairs where a soft underlay would creep. Underlay does most of the work for warmth, step and how long the pile stays upright, so it is matched to the floor and the traffic rather than sold as one grade for the whole house.