Carpet fitting in Ashton-under-Lyne

Almost always, with the right method. Local walls are old solid brick behind a soft lime skim, with the odd blocked-up chimney breast that swallows a fixing if it is not scanned first, so the substrate is scanned and tested first and the fixing chosen to suit. A standard Ashton-under-Lyne job takes around 59 minutes.

Access here is typically residents’ bay parking close to the door and a planned route past the stair spindles for large boards. Tameside Council controls parking in OL6, so any permit or visitor bay is arranged before the visit and included in the quoted price — never added afterwards.

Single room starts at from £129 and stairs with winders and landing is from £249. The price is set by the floor area, the number of stairs and whether the old carpet is being lifted and fixed in writing before we travel. Rates are identical across OL6, OL7 — postcode never changes the figure.

We do everything that can be done, photograph the problem with the part reference and tell you exactly what is needed. Returning to finish carries no second call-out charge in Ashton-under-Lyne.

Both. Most customers buy their own and we fit it; if you would rather we sourced it, send the room sizes and we will quote the carpet, underlay and fitting as one figure. That holds across OL6, OL7 at one fixed price.

Yes. Winders are cut and fitted individually rather than folded round, which takes longer but is the only way the treads sit tight and wear evenly. The same answer applies to every Ashton-under-Lyne booking.

Most Ashton-under-Lyne homes have original softwood floorboards over joists, usually cupped, gappy and springing at the hearth and doorways after a century of lifting for pipework. Before any gripper goes down we do the prep that floor needs: loose boards screwed back to the joists, proud nails punched down and a 3mm hardboard or 6mm ply overlay laid across the worst runs so the carpet reads flat instead of telegraphing every board line within a season. Prep is quoted on the survey with a price, not added on the day.

Typical here is a narrow straight flight turning onto two or three winders at the top, so treads and risers are cut, folded and stitched individually rather than run off one length. Straight treads are stretched and folded off one length; winders and open risers are templated, cut and stitched individually so the pile direction stays consistent down the flight and the nosings hold their shape.

Front rooms 3.6–4.2m across the bay, so a 4m broadloom is tight and the wider rooms take a planned seam set out of the traffic line, or a 5m roll where the hall will take the carry. Standard broadloom comes in 4m and 5m widths, so we measure on the survey and tell you before you buy whether the room fits seam-free — and if a seam is needed, where it will fall.

For this stock we specify 8–11mm PU foam over the overlaid boards for warmth and step, dropping to crumb rubber on the stairs where a soft underlay would creep. Underlay does most of the work for warmth, step and how long the pile stays upright, so it is matched to the floor and the traffic rather than sold as one grade for the whole house.